Mega Motion Rascal Owner's Manual Page 34

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 33
34
www.mega-motion.com Rascal
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and can
no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. The scooter will either display a diagnostic flash code or emit a beep code in the event one of
the conditions listed below develops.
NOTE: Your Travel Scooter will not run unless the beep code condition is resolved and the Travel
Scooter has been turned off, then turned back on.
What if all the systems on my Travel Scooter seem to be “dead”?
VIII. BASIC TROUBLESHOOTING
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Travel Scooter.”
Make certain that the battery and front-to-rear harnesses are secured properly.
Be sure the power down timer feature has not been activated. See V. “Operation.”
Check the fuse located inside the battery pack.
FAULT CODE CONDITION SOLUTION
(1)
Battery charge is low. Charge batteries as soon as possible.
  (2)
Battery charge is too low. Charge batteries.
   (3)
The Travel Scooter's battery voltage
is too high to operate the Travel
Scooter, or the charger is still con-
nected to the off-board charger port.
Unplug charger and/or turn key off,
then back on again.
    (4)
Current limit time out. Turn the Travel Scooter off for a
few minutes, then turn your Travel
Scooter back on.
    (5)
The manual freewheel lever is in the
(forward) freewheel position.
Remove the key from the key
switch, then push the manual free-
wheel lever to the drive (rearward)
position and restart your Travel
Scooter.
      (6)
Throttle control lever not at center
position at start up.
Return the throttle control lever to
center position, turn Travel Scooter
off then back on.
       (7)
Speed pot error. Call your authorized Mega Motion
Provider for assistance.
        (8)
Motor volts error. Call your authorized Mega Motion
Provider for assistance.
     
(9)
Other internal errors. Call your authorized Mega Motion
Provider for assistance.
Page view 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments